PRUSASLICER PROFILES CHANGELOG

2.1.0 (PrusaSlicer 2.8.1)

12. 9. 2024
  • Updated new parameters. PrusaSlicer 2.8.1 brings two new parameters: Filaments->Advanced->Abrasive material and Printers->Extruder->High flow nozzle. Both parameters will be used to check whether a sliced g-code is compatible with the given printer (abrasive material requires hardened nozzle). On the firmware side, this feature is supported since 6.2.0-alpha1.
  • Updated overhang fan speed overrides (MK4S).

2.0.5

12. 9. 2024

FFF printers

  • Fixed an issue in configuration wizard. The “MK4 MMU3 HF0.4” variant could not be enabled without also enabling non-HF 0.4 variant.

2.0.4

5. 9. 2024

FFF printers

  • Added profiles for VOXELPLA+ and VOXELPETG+ filaments
  • Updated compatible printer condition for specific filaments.

2.0.3

12. 8. 2024

FFF printers

  • Added printer profiles for Original Prusa MK4S and MK3.9S.
  • Added profiles for high flow nozzles (MK4/MK3.9/XL).
  • Printer profile “Original Prusa MK3.5” was renamed to “Original Prusa MK3.5 & MK3.5S”
  • Non-IS variants of MK4, MINI and XL printers were moved to the “Legacy profiles” section (bottom part of the list).
  • Added “0.20mm STRUCTURAL” profile for 0.3mm nozzle.
  • “Filatech FilaFlex” renamed to “Filatech FilaFlexible”.

2.0.2

25. 7. 2024

FFF printers

  • Added filament profile for Prusament Woodfill.
  • Added filament profile for BASF Ultrafuse TPU-64D (MK4/MK3.9/XL).
  • Updated FW version notification (6.0.4).