PRUSASLICER PROFILES CHANGELOG

FFF printers

• Updated FW version notification
• Decreased max ramping lift for flexible filaments (MK4/MK3.9).
• Reduced minimal fan speed for Prusament PETG, Prusa PETG, Generic PETG.
• Updated filament custom g-code condition for pressure advance value (XL/MK4/MK3.9).

1.13.2

SLA printers

• “Dental” category was renamed to “Medical”.
• Materials added: Prusament Resin Flex Anatomic Red, Prusament Resin Flex Gingiva Mask.
• Materials removed: All legacy/discontinued Prusa materials (vendor “Made for Prusa”).

1.13.1

FFF printers

• Enabled stealth mode support for XL, MINI, MK3.5, MK3.9, MK4.

SLA printers

• Materials added: Prusament Resin Model Transparent Clear

1.13.0

FFF printers

• Added profiles for MK4 MMU3 and MK3.9 MMU3.
• Updated start g-code for XL. The nozzle is cooled down during heat absorbtion phase to prevent oozing.
• Decreased bed temperature for some PETG filaments (XL, MINI).
• Decreased ramping lift max height for PETG filaments (XL/MK4/MK3.9 0.8mm nozzle).
• Increased acceleration value for top solid infill (MK4/XL 0.4n SPEED profiles).

FFF printers

• Updated start g-code for MK3.5 MMU3

VERSION 1.12.2

• Added new print profile “0.05mm DETAIL” for 0.25mm nozzle (IS variants of MK4/MK3.9/MK3.5/XL/MINI).
• Updated pressure advance values in selected filament profiles.
• Updated retraction settings and ramping lift setting for PETG 0.8mm nozzle (MK4/MK3.9/XL).
• Updated FW version notification (3.13.3 for MK2.5/MK3 family printers).
• Default seam position set to “nearest” (MINI IS 0.6mm nozzle).

VERSION 1.12.1

FFF printers

• Updated printer profile for “XLIS 5T 0.3mm nozzle” to fix issues with configuration wizard.
• Decreased maximum bridging distance on the wipe tower (MK3.5 MMU3 0.25mm nozzle).

VERSION 1.12.0 (released with PrusaSlicer 2.7.2)

FFF printers

• Enabled ramping z-hop for MK4 and MK3.9.

FFF printers

• Added profiles for Original Prusa MK3.5 MMU3.
• Added filament profile for Fiberlogy BVOH.
• Slightly decreased perimeter speeds in “SPEED” profiles to increase reliability with legacy and custom filament profiles (MK3.5 0.4 nozzle).
• Updated “SOLUBLE” print profiles (decreased XY spacing).

FFF printers

• Added profiles for Original Prusa MK3.5

FFF printers

• Decreased speed of sparse infill in STRUCTURAL profiles (0.4mm nozzle).
• Decreased max volumetric speed for some PETG filaments for better sparse infill quality and reliability (XL/MK4/3.9/MINI – 0.4mm nozzle).